RX2530 M4 Upgrade and Maintenance Manual 235
Expansion cards and backup units
Ê "Enabling replaced components in the BIOS" on page 93
Ê Inform the customer about changed WWN, MAC and SAS addresses, see
"Looking for MAC/WWN/GUID and SAS addresses" on page 100.
Ê "Updating the NIC configuration file in a Linux and VMware environment" on
page 97
Ê "Updating expansion card firmware" on page 85
Ê "Resuming BitLocker functionality" on page 98
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I Configuration of network settings should be performed by the
customer. For more information, see section "Note on network
settings recovery" on page 233.
Ê If applicable, restore LAN teaming configurations, see "After
replacing/upgrading LAN controllers" on page 105.
To Next Page
Loading...
