162 Upgrade and Maintenance Manual RX2530 M4
Hard disk drive (HDD) / solid state drive (SSD)
7.4.6.1 Preliminary steps
Ê "Locating the defective server" on page 47
Ê "Locating the defective component" on page 48
7.4.6.2 Removing the defective 2.5-inch HDD/SSD module
Ê Remove the HDD/SSD module, see section "Removing 2.5-inch HDD/SSD
modules" on page 159.
Ê If applicable, remove the HDD/SSD from the installation frame, see section
"Handling HDDs or SSDs without installation frame" on page 131.
7.4.6.3 Installing the new 2.5-inch HDD/SSD module
Ê If applicable, install the HDD/SSD in the installation frame, see section
"Handling HDDs or SSDs without installation frame" on page 131.
Ê Install the HDD/SSD module, see section "Installing 2.5-inch HDD/SSD
modules" on page 156.
7.4.6.4 Concluding steps
Ê If the HDD/SSD is configured using a RAID controller with a RAID level
higher than "0", the rebuild will start automatically, see section "Performing
a RAID array rebuild" on page 99.
To Next Page
Loading...
Need help?
General