RX2530 M4 Upgrade and Maintenance Manual 345
14.2.1.2 Removing the front panel module
Figure 252: Disconnecting the cables (A)
Ê Disconnect the front USB cable (1) and the front panel cable (2) from the
system board.
Figure 253: Disconnecting the cables (B)
Ê If applicable, disconnect the front VGA cable from the system board.
Figure 254: Removing the front panel module
Ê Remove the two screws (1).
Ê Pull the front panel module out of its bay (2) until the holder is completely
accessible.
To Next Page
Loading...
