RX2530 M4 Upgrade and Maintenance Manual 347
Figure 256: Connecting cables to the front panel module
Ê Connect the front panel cable and secure it with the cable tie (1).
Ê Push the front USB connector in the corresponding recess and fasten the
front USB cable with two screws (2).
Ê If applicable, connect the front VGA cable to the front VGA board and secure
it with the cable tie (3).
Figure 257: Installing the front panel module
Ê Push the front panel module in its bay (1).
Ê Fasten the front panel module with two screws (2).
To Next Page
Loading...
