388 Upgrade and Maintenance Manual RX2530 M4
System board and components
Figure 292: Removing the M.2 SSD (B)
Ê Pull the M.2 SSD out of its slot.
Ê If no new M.2 SSD will be installed:
Ê Fasten the screw to the corresponding hexagon stand-off (see orange
circles in figure 288).
16.5.2.3 Concluding steps
Ê "Reassembling" on page 57
Ê "Connecting the power cord" on page 63
Ê "Switching on the server" on page 66
16.5.3 Replacing an M.2 SSD
16.5.3.1 Preliminary steps
Ê "Locating the defective server" on page 47
Ê "Shutting down the server" on page 49
Ê "Disconnecting the power cord" on page 50
Ê "Getting access to the component" on page 52
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Software: 15 minutes
Tools: – Phillips PH1 / (+) No. 1 screw driver
To Next Page
Loading...
