RX2530 M4 Upgrade and Maintenance Manual 405
System board and components
16.7.1.3 Installing the new system board
Ê Check the settings on the new system board, see section "Onboard settings"
on page 433.
Ê Insert the system board by holding it at a slight angle. Slide the connectors
into the I/O panel (see figure 302 on page 404).
Ê Lower the system board carefully into the chassis.
Ê Adjust the system board. If necessary adjust the position of the system
board with a gentle twisting motion (orange circles in figure 301 on page 403
show the centering bolts).
Ê Fasten the system board with the 12 screws (see figure 301 on page 403).
Ê Fasten the four OCP bolts (see figure 300 on page 402).
Ê For Japan / APAC / North America only:
Replace the CMOS battery installed on the new system board with a new
CMOS battery (see section "Replacing the CMOS battery" on page 367),
because charging of CMOS battery might be reduced during stocked in
warehouse.
Ê System with air cooling:
Ê Remove the heat sink with the CPU from the defective system board, see
section "Removing the heat sink" on page 299.
Ê Remove the protective plastic cover from the CPU socket of the new
system board and fit it onto the socket of the defective system board
which will be sent back to spares.
I Returned system boards without this cover probably have to be
scrapped.
Ê Install the heat sink with the CPU on the new system board, see section
"Installing the CPU and heat sink" on page 303.
Ê System with liquid cooling:
Ê Remove the protective plastic cover from the CPU socket of the new
system board and fit it onto the socket of the defective system board
which will be sent back to spares.
I Returned system boards without this cover probably have to be
scrapped.
To Next Page
Loading...
