Garmin G2000 - IDENT Function

190-01263-01 Rev. A Garmin G2000 Pilot’s Guide for the Cessna T240 158
Audio And CnS
SYSTEM
oVERViEW
FLiGHT
inSTRuMEnTS
EiSAudio & CnS
FLiGHT
MAnAGEMEnT
HAZARd
AVoidAnCE
AFCS
AddiTionAL
FEATuRES
APPEndiCESindEX
VFR CODE
The VFR code can be entered either manually or by selecting the VFR Button. When the VFR Button is
selected, the pre-programmed VFR code is automatically displayed in the Transponder Mode Button.
The pre-programmed VFR Code is set at the factory to 1200. If a VFR code change is required, contact a
Garmin-authorized service center for configuration.
ident Function
note: In Standby Mode, the XPDR IDENT Button is inoperative.
Selecting the XPDR IDENT Button in the CNS Bar sends a distinct identity indication to Air Traffic Control
(ATC). The indication distinguishes the identing transponder from all the others on the air traffic controller’s
screen. When the XPDR IDENT Button is selected, the word IDENT turns green and pulsates for the duration
of the identity indication.
Figure 4-44 Transponder IDENT Indication
Transponder IDENT Active
This manual downloaded from http://www.manualowl.com