Garmin G2000 - Arrivals

190-01263-01 Rev. A
Garmin G2000 Pilot’s Guide for the Cessna T240
291
Flight ManageMent
SYSteM
OVeRVieW
Flight
inStRUMentS
eiS
aUDiO Panel
& CnS
Flight
ManageMent
haZaRD
aVOiDanCe
aFCS
aDDitiOnal
FeatUReS
aPPenDiCeS inDeX
arrivalS
A Standard Terminal Arrival (STAR) can be loaded at any airport that has one available. Only one arrival
can be loaded at a time in a flight plan. If an arrival is loaded when another arrival is already in the active
flight plan, the new arrival replaces the previous arrival. The route is defined by selection of an arrival, the
transition waypoints, and a runway.
LOADING AN ARRIVAL INTO THE ACTIVE FLIGHT PLAN
Loading an arrival into the active flight plan using the Touchscreen Controller:
1) From Home, touch PROC
2) Touch the Arrival Button to display the Arrival Selection Screen.
3) If necessary, touch the Airport Button to display the keypad and use it to select the arrival airport.
4) Touch the Enter Button to accept the arrival airport.
5) If necessary, touch the Arrival Button to display the Select Arrival Screen with a list of available arrivals.
6) Scroll the list if necessary and touch an arrival selection button to select the arrival.
7) If necessary, touch the Transition Button to display the Select Transition Screen with a list of available transitions.
8) Scroll the list if necessary and touch a transition selection button to select the transition.
9) If necessary, touch the Runway Button to display the Select Runway Screen with a list of available runways.
10) Scroll the list if necessary and touch a runway selection button to select the runway and return to the Arrival
Selection Screen.
11) Touch the Preview Button, then the Show on Map Button to show the preview of the arrival.
12) Touch the Load Button to insert the arrival into the active flight plan.
This manual downloaded from http://www.manualowl.com