Garmin G2000 Pilot’s Guide for the Cessna T240
190-01263-01 Rev. A544
AdditionAl FeAtures
sYsteM
oVerVieW
FliGHt
instruMents
eis
Audio PAnel
& Cns
FliGHt
MAnAGeMent
HAZArd
AVoidAnCe
AFCs
AdditionAl
FeAtures
APPendiCesindeX
8.12 ELECTRONIC CHECKLISTS (OPTIONAL)
NOTE: The checklists presented in this section are for example only and may not reflect checklists actually
available for the Cessna T240. The information described in this section is not intended to replace the
checklist information described in the AFM or the Pilot Safety and Warning Supplements document.
NOTE: Garmin is not responsible for the content of checklists. User-defined checklists are created by the
aircraft manufacturer. Modifications or updates to the checklists are coordinated through the aircraft
manufacturer. The user cannot edit these checklists.
The Display Panes are able to display optional electronic checklists (supplied by the manufacturer) which
allow the pilot to quickly find the proper procedure on the ground and during each phase of flight. The system
accesses the checklists from the Supplemental Data Cards located in the bottom card slot of PFD and MFD.
If the SD card contains an invalid checklist file or no checklist, the Power-up Page messages display ‘Checklist
File: Invalid’ or ‘Checklist File: N/A’ (not available) and Checklist is not available on the Home Screen.
The following colors are used for checklist items:
• Light Blue - Items not selected or checked
• White - Item is selected
• Green - Item has been checked
• Gray - General notes
• Yellow - Caution notes
• Red - Warning notes
Accessing and navigating checklists:
1) From the Home Screen, touch Checklist.
2) Touch the tab pertaining to the desired checklist category. The STARTING ENGINE Tab is selected in this
example, as seen in Figure 8-122.
3) Touch the desired checklist from those listed in the center of the screen. If necessary, scroll through the list to
see all the available checklists for the selected group. In Figure 8-122, BEFORE STARTING ENGINE is selected
and the checklist is displayed in the previously selected Display Pane as in Figure 8-123. The first checklist item
is selected as indicated by the white text surrounded by a white box.
Figure 8-123 Selected Checklist DisplayedFigure 8-122 Select Checklist Category & Checklist
This manual downloaded from http://www.manualowl.com
To Next Page
Loading...
Need help?
General
