Garmin G2000 Pilot’s Guide for the Cessna T240
190-01263-01 Rev. A292
Flight ManageMent
SYSteM
OVeRVieW
Flight
inStRUMentS
eiS
aUDiO Panel
& CnS
Flight
ManageMent
haZaRD
aVOiDanCe
aFCS
aDDitiOnal
FeatUReS
aPPenDiCeSinDeX
Runway
Selection
Button
Figure 5-145 Loading an Arrival into the Active Flight Plan
Arrival
Sequence
Loaded
Arrival
Load
Button
Arrival
Selection
Button
Airport
Button
Transition
Selection
Button
Arrival
Button
Transition
Button
Runway
Button
Remove
Button
Preview
Button
Loading an arrival into the active flight plan using the GDU Controller:
1) Press the PROC Key. The Procedures Window is displayed.
2) Highlight ‘SELECT ARRIVAL’.
3) Press the ENT Key or the small PFD Knob. The Select Arrival Window is displayed.
4) Use the PFD Knob to select an airport and press the ENT Key or the small PFD Knob.
5) Select an arrival from the list and press the ENT Key or the small PFD Knob.
6) Select a runway (if required) and press the ENT Key or the small PFD Knob.
7) Select a transition (if required) and press the ENT Key or the small PFD Knob. ‘LOAD?’ is highlighted.
8) Press the ENT Key or the small PFD Knob to load the arrival procedure.
This manual downloaded from http://www.manualowl.com
To Next Page
Loading...
