Garmin G2000 Pilot’s Guide for the Cessna T240
190-01263-01 Rev. A278
Flight ManageMent
SYSteM
OVeRVieW
Flight
inStRUMentS
eiS
aUDiO Panel
& CnS
Flight
ManageMent
haZaRD
aVOiDanCe
aFCS
aDDitiOnal
FeatUReS
aPPenDiCeSinDeX
Creating a user-defined hold at a Direct To waypoint:
1) From Home, touch Flight Plan
2) Touch the Direct-To Button and set up the Direct To waypoint as desired.
3) Touch the Hold Button. The Direct To Hold Screen is displayed.
4) Touch the Turn Direction Button, and touch the Right Button or the Left Button to select the turn direction.
5) Touch the Course Direction Button, and touch the Inbound Button or the Outbound Button to select the
course direction.
6) Touch the Hold Entry Course Button to display the keypad. Use the keypad and the Enter Button to select the
entry angle.
7) Touch the Leg Length Mode Button, and touch the Distance Button or the Time Button to select the length
mode.
8) Touch the Leg Time Button or the Leg Distance Button to display the keypad. Use the keypad and the Enter
Button to select the length of the leg.
9) Touch the Expect Further Clearance Button to display the keypad. Use the keypad and the Enter Button to
select the time for a reminder.
10) Touch the Enter Button to return to the Direct To Screen.
11) Touch the Activate Direct To Button to activate the Direct-To and add the hold into the flight plan.
Figure 5-129 Creating a User Defined Holding Pattern at a Direct To Waypoint
Leg Length Mode Button
(Time or Distance)
Expect Further Clearance Button
Turn Direction Button
Hold at Present Position Button
Hold Location Information
Cancel Hold Button
Leg Time or Leg Distance Button
Hold Entry Course Button
Course Direction Button
(Inbound or Outbound)
Show on Map Button
Direct To
Button
Hold
Button
This manual downloaded from http://www.manualowl.com
To Next Page
Loading...
