190-01263-01 Rev. A
Garmin G2000 Pilot’s Guide for the Cessna T240
289
Flight ManageMent
SYSteM
OVeRVieW
Flight
inStRUMentS
eiS
aUDiO Panel
& CnS
Flight
ManageMent
haZaRD
aVOiDanCe
aFCS
aDDitiOnal
FeatUReS
aPPenDiCeS inDeX
Runway
Selection
Button
Figure 5-143 Loading a Departure into the Active Flight Plan
Departure
Sequence
Loaded
Departure
Load
Button
Departure
Selection
Button
Airport
Button
Transition
Selection
Button
Departure
Button
Transition
Button
Runway
Button
Remove
Button
Preview
Button
Loading a departure into the active flight plan using the GDU Controller:
1) Press the PROC Key. The Procedures Window is displayed.
2) Highlight ‘SELECT DEPARTURE’.
3) Press the ENT Key or the small PFD Knob. The Select Departure Window is displayed.
4) Use the PFD Knob to select an airport and press the ENT Key or the small PFD Knob.
5) Select a departure from the list and press the ENT Key or the small PFD Knob.
6) Select a runway (if required) and press the ENT Key or the small PFD Knob.
7) Select a transition (if required) and press the ENT Key or the small PFD Knob. ‘LOAD?’ is highlighted.
8) Press the ENT Key or the small PFD Knob to load the departure procedure.
This manual downloaded from http://www.manualowl.com
To Next Page
Loading...
