Garmin G2000 Pilot’s Guide for the Cessna T240
190-01263-01 Rev. A306
Flight ManageMent
SYSteM
OVeRVieW
Flight
inStRUMentS
eiS
aUDiO Panel
& CnS
Flight
ManageMent
haZaRD
aVOiDanCe
aFCS
aDDitiOnal
FeatUReS
aPPenDiCeSinDeX
Selecting the Active Flight Plan - Remaining trip route mode:
1) From Home, touch Utilities > Trip Planning
2) Touch the Trip Route Button to display the Input Selection Window.
3) Touch the Select from Flight Plan Button to display the Select Flight Plan Screen.
4) Scroll the list, if necessary, and touch the active flight plan button to display the Select Flight Plan Leg Screen.
5) Touch the Remaining Flight Plan Button to select the mode and return to the Trip Planning Screen.
Selecting the Active Flight Plan - Leg trip route mode:
1) From Home, touch Utilities > Trip Planning
2) Touch the Trip Route Button to display the Input Selection Window.
3) Touch the Select from Flight Plan Button to display the Select Flight Plan Screen.
4) Scroll the list, if necessary, and touch the active flight plan button to display the Select Flight Plan Leg Screen.
5) Scroll the list, if necessary, and touch a flight plan leg selection button to select the mode and return to the Trip
Planning Screen.
Selecting the waypoints trip route mode:
1) From Home, touch Utilities > Trip Planning
2) Touch the Trip Route Button to display the Input Selection Window.
3) Touch the Select Starting and Ending Waypoints Button to display the Select Starting and Ending Locations
Window.
4) Touch the starting waypoint button to display the Select Starting Location Window.
5) Touch the Present Position Button to use the present position of the aircraft and return to the Select Starting
and Ending Locations Window.
Or:
5) Touch the Waypoint Button to select a waypoint using the keypad and return to the Select Starting and Ending
Locations Window.
6) Touch the ending waypoint button to to select a waypoint using the keypad and return to the Select Starting
and Ending Locations Window.
7) Touch the Accept Button to select the mode and return to the Trip Planning Screen.
When the manual entry mode is selected, the other eight trip input data fields must be entered by the pilot,
in addition to flight plan and leg selection.
Entering manual data for trip statistics calculations:
1) From Home, touch Utilities > Trip Planning
2) Touch the Manual Entry Button to enable the manual entry data field buttons.
3) Touch an input data field button and use the keypad to select the value.
4) Touch the Enter Button to accept the value and return to the Trip Planning Screen.
5) Repeat steps 3 and 4 for each of the data fields.
This manual downloaded from http://www.manualowl.com
To Next Page
Loading...
