Garmin G2000 - Page 518

Garmin G2000 Pilot’s Guide for the Cessna T240
190-01263-01 Rev. A504
AdditionAl FeAtures
sYsteM
oVerVieW
FliGHt
instruMents
eis
Audio PAnel
& Cns
FliGHt
MAnAGeMent
HAZArd
AVoidAnCe
AFCs
AdditionAl
FeAtures
APPendiCesindeX
Power-up Display Definition
Blank Line. System is not configured for FliteCharts. Contact a Garmin-
authorized service center for configuration.
System is configured for FliteCharts but no chart database is installed.
Refer to Updating Garmin Databases in Appendix B for the FliteCharts
database
Normal operation. FliteCharts database is valid and within current
cycle.
FliteCharts database is beyond the expiration date, but still within the
180 day viewing period.
FliteCharts database has timed out. Database is beyond 180 days
after expiration date. FliteCharts database is no longer available for
viewing.
Table 8-3 FliteCharts Annunciations and Definitions
‘FliteCharts Expires’ plus a date in white, indicates the chart database is current. ‘Chart data is out of date!’
in yellow, indicates charts are still viewable, but approaching the disable date.
When the 180 day grace period has expired, ‘Chart data is disabled.’ in yellow indicates that the FliteCharts
database has expired and is no longer viewable. ‘Chart Data: N/A’ appears in white if no FliteCharts data is
available on the database card or no database card is inserted.
FliteCharts status information can be found on the MFD1, PFD1, and GTC1 Databases Screens (Figure 8-32).
The ‘Expires’ date is the revision date for the next database cycle. The ‘Expires’ date appears in yellow when
expired.
FliteCharts becomes inoperative 180 days after the FliteCharts ‘Expires’ date is reached, and is no longer
available for viewing. This date is shown as the ‘Disables’ date. When the disables date is attained, the date is
displayed in yellow. Also, Charts Button on the Home Screen then appears subdued and is disabled until a
new issue of FliteCharts is installed.
Viewing FliteCharts database information:
1) From the Home Screen, touch Utilities > Setup > Avionics Status.
2) Touch the Database Tab.
3) Touch the button corresponding to the display (MFD1, PFD1, or GTC1) for which the database information will
be viewed.
This manual downloaded from http://www.manualowl.com