190-01263-01 Rev. A
Garmin G2000 Pilot’s Guide for the Cessna T240
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
559
Appendix A
GIA 63W INTEGRATED AVIONICS UNIT SYSTEM MESSAGES
System Message Comments
GIA1 CONFIG
– GIA1 config
error. Config service req’d.
The GIA1 and/or GIA2 configuration settings do not match backup configuration memory. The
system should be serviced.
GIA2 CONFIG
– GIA2 config
error. Config service req’d.
GIA1 CONFIG
– GIA1 audio
config error. Config service
req’d.
The GIA1 and/or GIA2 have an error in the audio configuration. The system should be serviced.
GIA2 CONFIG
– GIA2 audio
config error. Config service
req’d.
GIA1 COOLING
– GIA1
temperature too low.
The GIA1 and/or GIA2 temperature is too low to operate correctly. Allow units to warm up to
operating temperature.
GIA2 COOLING
– GIA2
temperature too low.
GIA1 COOLING
– GIA1 over
temperature.
The GIA1 and/or GIA2 temperature is too high. If problem persists, the system should be serviced.
GIA2 COOLING
– GIA2 over
temperature.
GIA1 SERVICE
– GIA1 needs
service. Return the unit for
repair.
The GIA1 and/or GIA2 self-test has detected a problem in the unit. The system should be serviced.
GIA2 SERVICE
– GIA2 needs
service. Return the unit for repair.
HW MISMATCH
– GIA1
hardware mismatch, GIA1
communication halted.
A GIA mismatch has been detected, where only one is WAAS capable.
HW MISMATCH
– GIA
hardware mismatch, GIA2
communication halted.
GIA1 MANIFEST
– GIA1
software mismatch,
communication halted.
The GIA1 and/or GIA 2 has incorrect software installed. The system should be serviced.
GIA2 MANIFEST
– GIA2
software mismatch,
communication halted.
GFC MANIFEST
– GFC software
mismatch, communication halted.
Incorrect servo software is installed, or gain settings are incorrect.
COM1 TEMP
– COM1 over temp.
Reducing transmitter power.
The system has detected an over temperature condition in COM1 and/or COM2. The transmitter
operates at reduced power. If the problem persists, the system should be serviced.
COM2 TEMP
– COM2 over temp.
Reducing transmitter power.
This manual downloaded from http://www.manualowl.com
To Next Page
Loading...
