190-01263-01 Rev. A
Garmin G2000 Pilot’s Guide for the Cessna T240
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
561
Appendix A
System Message Comments
GPS1 FAIL
– GPS1 is
inoperative.
A failure has been detected in GPS receiver #1 and/or GPS receiver #2. The system should be
serviced.
GPS2 FAIL
– GPS2 is
inoperative.
NAV1 SERVICE
– NAV1 needs
service. Return unit for repair.
A failure has been detected in the NAV1 and/or NAV2 receiver. The receiver may still be available.
The system should be serviced.
NAV2 SERVICE
– NAV2 needs
service. Return unit for repair.
NAV1 RMT XFR
– NAV1
remote transfer key is stuck.
The remote NAV1 and/or NAV2 transfer switch is stuck in the enabled (or “pressed”) state. Press
the transfer switch again to cycle its operation. If the problem persists, the system should be
serviced.
NAV2 RMT XFR
– NAV2
remote transfer key is stuck.
G/S1 FAIL
– G/S1 is inoperative.
A failure has been detected in glideslope receiver 1 and/or receiver 2. The system should be
serviced.
G/S2 FAIL
– G/S2 is inoperative.
G/S1 SERVICE
– G/S1 needs
service. Return unit for repair.
A failure has been detected in glideslope receiver 1 and/or receiver 2. The receiver may still be
available. The system should be serviced when possible.
G/S2 SERVICE
– G/S2 needs
service. Return unit for repair.
NAV1 MANIFEST
– NAV1
software mismatch,
communication halted.
The NAV 1 and/or NAV 2 has incorrect software installed. The system should be serviced.
NAV2 MANIFEST
– NAV2
software mismatch,
communication halted.
GDC 74A AIR DATA COMPUTER SYSTEM MESSAGES
System Message Comments
GDC1 MANIFEST
– GDC
1 software mismatch,
communication halted.
The GDC 74A has incorrect software installed. The system should be serviced.
ADC1 ALT EC – ADC1 altitude
error correction is unavailable.
GDC1 is reporting the altitude error correction is unavailable.
ADC1 AS EC – ADC1 airspeed
error correction is unavailable.
GDC1 is reporting the airspeed error correction is unavailable.
ADC1 SERVICE – ADC1 needs
service. Return unit for repair.
The GDC74A should be serviced..
This manual downloaded from http://www.manualowl.com
To Next Page
Loading...
