Garmin G2000 - Page 610

Garmin G2000 Pilot’s Guide for the Cessna T240
190-01263-01 Rev. A
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
596
Appendix d
For RAIM to work correctly, the GPS receiver must track at least five satellites. A minimum of six satellites is
required to allow RAIM to eliminate a single corrupt satellite from the navigation solution.
RAIM ensures that satellite geometry allows for a navigation solution calculation within a specified protection
limit (2.0 nm for oceanic and en route, 1.0 nm for terminal, and 0.3 nm for non-precision approaches). The
system monitors RAIM and issues an alert message when RAIM is not available (see Appendix A). Without
RAIM, GPS position accuracy cannot be monitored. If RAIM is not available when crossing the FAF, the pilot
must fly the missed approach procedure.
WHy migHt tHere Be no aPProacHeS availaBle for a fligHt Plan?
Approaches are available for the final destination airport in a flight plan or as a direct-to (keep in mind some
VOR/VORTAC identifiers are similar to airport identifiers). If a destination airport does not have a published
approach, the system indicates “NONE” for the available procedures.
WHat HaPPenS WHen an aPProacH iS SelecteD? can a fligHt Plan WitH an aPProacH, a DePartUre, or an
arrival Be StoreD?
When an approach, departure, or arrival is loaded into the active flight plan, a set of approach, departure,
or arrival waypoints is inserted into the flight plan, along with a header line showing the title of the selected
instrument procedure. The original enroute portion of the flight plan remains active, unless the instrument
procedure is activated. This may be done either when the procedure is loaded or at a later time.
Flight plans can also be stored with an approach, a departure, or an arrival. Note the active flight plan is
erased when the system is turned off. Also, the active flight plan is overwritten when another flight plan is
activated. When storing flight plans with an approach, a departure, or an arrival, the system uses the waypoint
information from the current database to define the waypoints. If the database is changed or updated, the
system automatically updates the information, provided the procedure has not been modified. Should an
approach, departure, or arrival procedure no longer be available, the flight plan becomes locked until the
procedure is deleted from the flight plan.
can “Slant golf” (“/g”) Be fileD for a fligHt Plan for a g2000 aircraft?
“/G” may be filed for a flight plan. GPS approaches are not to be flown with an expired database. See
the approved Airplane Flight Manual (AFM) as well as the Aeronautical Information Manual (AIM) for more
information.
WHat DoeS tHe oBS Softkey Do?
The OBS Softkey is used to select manual sequencing of waypoints. Activating OBS mode sets the current
active-to waypoint as the primary navigation reference and prevents the system from sequencing to the next
waypoint in a flight plan. When OBS mode is cancelled, automatic waypoint sequencing is continued, and
the system automatically activates the next waypoint in the flight plan once the aircraft has crossed the present
active waypoint.
This manual downloaded from http://www.manualowl.com