Garmin G2000 - Page 612

Garmin G2000 Pilot’s Guide for the Cessna T240
190-01263-01 Rev. A
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICESINDEX
598
Appendix d
HoW Do i activate a miSSeD aPProacH ProceDUre?
To comply with TSO specifications, the system does not automatically sequence past the MAP. The first
waypoint in the missed approach procedure becomes the active waypoint when the SUSP Button is selected
after crossing the MAP. All published missed approach procedures must be followed, as indicated on the
published approach.
To execute the missed approach procedure prior to the MAP (not recommended), touch the PROC Button on
the Home Screen or the Active Flight Plan Screen. Touch the Activate Missed Approach Button to activate
the missed approach portion of the procedure.
after a miSSeD aPProacH, HoW can tHe Same aPProacH Be re-SelecteD? HoW can a neW aPProacH Be
activateD?
NOTE : Do not attempt to reactivate the current approach prior to crossing the missed approach point
(MAP). If an attempt to do so is made, an alert message “Are you sure you want to discontinue the current
approach?” appears. The system directs the pilot back to the transition waypoint and does not take into
consideration any missed approach procedures, if the current approach is reactivated.
After flying the missed approach procedure, the pilot may reactivate the same approach for another attempt
by touching the
PROC Button on the Home Screen, followed by the Activate Approach Button. The system
provides navigation along the desired course to the waypoint and rejoins the approach in sequence from that
point.
To activate a new approach for the same airport, select the new procedure by touching the
PROC Button,
then touch the Approach Button to access the Approach Selection Screen. Then touch the Approach Button.
The Touchscreen Controller displays a list of approaches as buttons. Scroll as needed and touch the desired
approach button, then touch a transition button. The Touchscreen Controller returns to the Approach Selection
Screen. To activate the selected approach, touch the Load & Activate Button.
To activate a new approach to a different airport, touch the Direct To Button to access the Direct To Screen.
Then touch the waypoint point and enter the desired airport using the keypad or large and small right knobs.
Touch the Enter Button or push the Right Knob to accept the selected airport, then follow the steps in the
preceding paragraph to select an approach for the new airport.
This manual downloaded from http://www.manualowl.com