GE HEALTHCARE
DIRECTION 5394141, REVISION 5 LOGIQ™ P5 SEVICE MANUAL
8-160 Section 8-4 - Software Installation
8-4-4-9 Regional Setup Procedure for Japanese
You can set up the keyboard for Japanese. If you select Japanese, the following items display or may
be entered in Japanese.
• Patient Name
• Exam Comment (on Patient screen and Worksheet)
• Annotation (Comments)
• Error/Warning Messages
• DICOM/Worklist
1.) In Utility--> System--> General, set the Language as JPN. Save this setting, but do not reboot the
system yet.
2.) Press Regional Options, under Standards and Formats select Japanese, under Location select
Japan. Press Apply.
Figure 8-221 Changing the System Language to JPN
Figure 8-222 Regional Options
To Next Page
Loading...
