9
Measurement process
11
Check the measurement results. (p. 41)
• To enlarge the measured value display: p. 42
• To change the number of digits used to display
measured values: p. 87
• When you want to judge the measurement results:
To perform comparator measurement (p. 69), To
perform BIN measurement (p. 74)
• When you want to save the measurement results:
To save the desired number of measurement
data points (p. 86)
To save one measurement data point before the
save was performed to the USB ash drive in the
CSV format (p. 141)
An error message or error display will be shown:
Error massage
Reference Value: No measured value accuracy guarantee
Memory Full: Memory full
Hi Z: Hi Z reject error
Error display
See “11.3 Error Massage and Error Display” (p. 230).
The following functionality is also available
Measuring conductivity and dielectric constant
p. 67
Measuring at a high level of precision
p. 55
Limiting instability of display values
p. 56
Setting measurement conditions for each measurement range
p. 79
Increasing the measurement precision or measurement speed
p. 82
Detecting contact errors during two-terminal measurement
p. 84
Detecting poor contact with the sample during four-terminal measurement
p. 85
Changing the key tone or judgment tone
p. 89
Disabling key operation (key lock function)
p. 90
Performing measurement by outputting a signal from an external device
to the instrument
p. 62, p. 161
Controlling the instrument by sending commands from a computer
p. 132
Saving settings data to the USB ash drive
p. 153
Loading settings data from the USB ash drive
p. 155
10
9
8
7
6
5
4
3
2
1
付録索引
To Next Page
Loading...
