About This User Manual D1 Servo Drive User Manual
1-2 HIWIN MIKROSYSTEM CORP.
1.1 General precautions
Before using the product, please carefully read through this user manual. HIWIN Mikrosystem (HIWIN) is
not responsible for any damage, accident or injury caused by failure in following the installation
instructions and operating instructions stated in this user manual.
◆ Do not disassemble or modify the product. The design of the product has been verified by structural
calculation, computer simulation and actual testing. HIWIN is not responsible for any damage,
accident or injury caused by disassembly or modification done by user.
◆ Before installing or using the product, ensure there is no damage on its appearance. If any damage
is found after inspection, please contact HIWIN or local distributors.
◆ Carefully read through the specifications noted on the product label or technical document. Install the
product according to its specifications and installation instructions stated in this user manual.
◆ Ensure the product is used with the power supply specified on the product label or in the product
requirement. HIWIN is not responsible for any damage, accident or injury caused by incorrect power
supply.
◆ Ensure the product is used with its rated load. HIWIN is not responsible for any damage, accident or
injury caused by improper usage.
◆ Do not subject the product to shock. HIWIN is not responsible for any damage, accident or injury
caused by improper usage.
◆ If an error occurs in the servo drive, please refer to section 9.4 and follow the instructions for
troubleshooting. After the error is cleared, power on the servo drive again.
◆ Do not repair the product by yourself when it malfunctions. The product can only be repaired by
qualified technician from HIWIN.
HIWIN offers 1 year warranty for the product. Warranty starts on the shipping date of the product. The
warranty does not cover damage caused by improper usage (Refer to the notices and instructions stated
in this user manual.) or natural disaster.
The maximum ambient temperature must be below 55
o
C.
The product can only be installed in an environment with pollution degree not exceeding 2.
The control power input must be: 24 Vdc, 1 A and level 2.
The rated voltage input is 240 V. Short-circuit current must be below 5000 A.
Before inspection, please turn off the power and wait for at least 5 minutes. To avoid electric shock, ensure the
residual voltage between P and N terminals has dropped to 50 Vdc or lower by using multimeter.
To Next Page
Loading...
