2-6
System Error Codes
HP Designjet 4000/4020 Printer Series Service Manual
System Error:
06:03
Problem
Description:
NVM file has bad CRC.
Corrective Action:
Try the following:
îš„ Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
 If the System Error continues, replace the Hard Disk Drive ⇒ Page 8-107.
System Error:
06:10
Problem
Description:
Main NVM failure - not detected, read/write failed or readback error.
Corrective Action:
Try the following:
îš„ Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
 If the System Error continues, replace the Hard Disk Drive ⇒ Page 8-107.
System Error:
07:10
Problem
Description:
Aerosol Fan driver burnt.
Corrective Action:
Try the following:
îš„
Replace the Interconnect PCA
⇒
Page 8-93.
îš„
If the System Error continues, replace the Gamut PCI PCA
⇒
Page 8-98.
Only replace one component at a time and check if the error
has gone before replacing another component. Using this
procedure you will be able to determine exactly which
component failed.
System Error:
08:11
Problem
Description:
Problem with the Front Panel.
Corrective Action:
Try the following:
îš„ Switch the Power OFF from the back of the Printer and disconnect the
Power cord. Reconnect the power cord and power On the Printer.
îš„
If the printer emits one or multiple ’beeps’ as the printer turns On, perform
the procedure ’Using the buzzer at Power-up to Troubleshoot
⇒
Page 1-9.
îš„ Check that the Front Panel cable is not damaged and is correctly
connected to the Front Panel and to the Interconnect PCA.
îš„ Check that the Memory Module is installed correctly.
îš„ Check that the cables between the Interconnect PCA and the Main PCA
are not damaged and are correctly connected.
îš„ Check that the cables between the Hard Disk Drive and the Power Supply
Unit and the Main PCA are not damaged and are correctly connected.
To Next Page
Loading...
Need help?
General