Hurco winmax - Page 292

XIV - Index v546CO WinMax Lathe Conversational Part Programming
MOVE TO POSITION
Position datablock 2-4
MOVE TO TOOL CHANGE
Position datablock 2-4
MOVE TO Z POSITION field
Move Tailstock screen 2-206
MOVE TURRET HOME
Position datablock 2-4
MOVE W HOME F6 softkey
Position datablock 2-4
MOVE W ONLY F5 softkey
Position datablock 2-4
MOVE X THEN Z
Axis Order field, User Defined Tool
Change Position area in Program
Parameters screen 2 - 194
MOVE Y HOME F2 softkey
Position datablock 2-4
MOVE Y ONLY F15 softkey
Position datablock 2-4
MOVE Z THEN X
Axis Order field, User Defined Tool
Change Position area in Program
Parameters screen 2 - 194
MULTIPLE BLOCK FUNCTIONS F1 softkey
program review 1-10
multiple blocks, select for editing 1-9
N
NC Conversational Merge (NC Program
Call) 2-202
NC PROGRAM CALL F6 softkey 2 - 210
New Axial Contour Segment screen 2-135
New Block screen
TMM series 2-2
New Radial Contour Segment screen 2-78
NEXT ELEMENT F2 softkey 2-25, 2-26
NEXT HOLE OPERATION F2 softkey
Axial Holes screen 2-178
Radial Holes screen 2-114
NONE field, Comment block stop type 2-
201
NUMBER field, Grooving Cycle screen 2-
57
NUMBER OF HOLES field
Axial Bolt Circle screen, Polar
Coordinates 2-185
Radial Holes Loop Around C-Axis screen
2 - 123
NUMBER OF PASSES field, Threading Cycle
2-39
NUMBER OF SIDES field
Axial Mill Flats screen
Polar Coordinates 2 - 171
Rectangular Coordinates 2-173
NUMBER OF STARTS
Threading 2-42, 2-44, 2-46, 2-48,
2-50
O
OD Straight Thread Type 2-41
OD Taper
infeed angle 2-44
pullout angle 2-44
OD Taper Thread Type 2-43
OFFSET field
Grooving cycle 2-57
Offset Spindles field
Transfer block screen 2 - 208
offsets
save and restore 2 - 197
OFFSETS field
Cutoff block 2-63
Grooving 2-52
Hole cycle 2-59
ON field
Axial Mill Circle screen 2-148
Axial Mill Contour screen 2 - 129
Axial Mill Frame screen 2-154
Cutter Compensation 2-189
Radial Mill Circle screen 2-90
Radial Mill Contour screen 2-72
Radial Mill Frame screen 2-96
On Sub-spindle check box
Change Part Setup 2 - 196
on-screen calculator -viii
on-screen cursor 1-7
OPERATION field
Profile Start screen 2-13
optional AT-Keyboard 1-7
OPTIONAL field
Comment block stop type 2 - 201
Program Stop 2-7
optional stop 1-4
ORIENTATION field
Axial Lettering screen 2-176
Grooving 2-54
Radial Lettering screen 2-111
OUT/TAN (OUTSIDE TANGENT) field
Axial Mill Circle screen 2-148
Axial Mill Frame screen 2-154
Cutter Compensation 2-189
Radial Mill Circle screen 2-90
Radial Mill Frame screen 2-96
OUTSIDE field
Axial Mill Circle screen 2-148
Axial Mill Frame screen 2-154
Cutter Compensation 2-189