Hypertherm MicroEdge - Files; Load from Disk; Load from

Files 93
Files
Load from Disk
The following screen is used to load a part from a diskette, USB memory stick or the hard drive.
Once all the parameters below are set, press ENTER on the keyboard to load the part.
Load from
The Load from list selects whether you load from the diskette, USB memory stick or from a directory
on the hard disk. To add or remove a directory, double click on the touch screen where indicated.
Keypad operation: To select a different directory, use the  and  keys on the keyboard. To add or
remove new directory use the + or – key.
Files
The Files list box is a list of all the files that are in the Load from directory that can be loaded from the
disk.
Keypad operation: To scroll through different files, use the , , PAGE UP and PAGE DOWN keys
on the keyboard. To remove a file, use the - key on the keyboard. To select multiple files to load,
highlight the first file selection, then use the  and  keys while pressing the shift key to highlight the
remaining files. Note: Multiple file selection is only available if loading from the Diskette or USB
memory stick to the hard drive.