Hypertherm MicroEdge User Manual

Setups 38
Ignition Time
Specifies the length of time that the oxy fuel igniter is held on at each ignition of the flame.
Low Preheat
For those cutting systems that are equipped with a Low Preheat feature, this parameter allows the
operator to input a timing delay to activate the Low Preheat output prior to the High Preheat.
High Preheat
Specifies the length of time to wait at each pierce position for preheating the piece prior to piercing.
During the run-time, the operator may use the SET, EXTEND, or RELEASE soft keys to customize
the preheat length for the particular metal being cut.
Pierce Time
Specifies the amount of delay after the cutting gas is turned on before lowering the torch to the cut
position.
Moving Pierce Time
The Moving Pierce Time parameter specifies the amount of time that the Pierce Output remains on
while piercing with motion.

Hypertherm MicroEdge Specifications

General

Brand	Hypertherm
Model	MicroEdge
Category	Control Systems
Language	English