Hypertherm MicroEdge - THC and Joystick Interface; Series 1 PCI Analog Card; Thc 1; Thc 2

To Next Page

To Previous Page

MicroEdge™ 491

THC and Joystick Interface

MicroEdge® has dedicated connectors for THC 1, THC and Joystick / Speedpots.

Series 1 PCI Analog Card

Note: The Analog Card will be designated as PCI-AIC Rev A in the Control Information Diagnostic

screen.

Board Marking PCI Analog 1 Part # PCBS-0074

THC 1

Pin # Designation Description

1 Common Common

2 Input 5 + Nozzle Contact Sense + ( Relay Contact )

3 Input 5 – Nozzle Contact Sense - ( Relay Contact )

4 Output 1 + Nozzle Contact Enable + ( Relay Contact )

5 Output 1 – Nozzle Contact Enable - ( Relay Contact )

6 Analog Input 1 + THC +

7 Analog Input 1 – THC –

8 Output 2 + Hold Ignition ( Relay Contact )

9 Output 2 – Hold Ignition ( Relay Contact )

Ground Stud Shield

Mating Connector

Connector AMP #206708-1

Backshell AMP #206966-1

Sockets (20-24 ga) AMP #66105-3

Cabling: Use Belden # 9504 or equivalent

THC 2

Pin # Designation Description

1 Common Common

2 Input 6 + Nozzle Contact Sense + ( Relay Contact )

3 Input 6 – Nozzle Contact Sense – ( Relay Contact )

4 Output 3 + Nozzle Contact Enable + ( Relay Contact )

5 Output 3 – Nozzle Contact Enable – ( Relay Contact )

6 Analog Input 2 + THC +

7 Analog Input 2 – THC –

8 Output 4 + Hold Ignition ( Relay Contact )