Overview 26
Setups Screen
The Setups Screen is used to configure the control for use.
Cutting
Allows programming of the different cutting parameters and dwell times.
Process
Enters the cut type menu, which allows editing of gas control sequencing variables for oxy-fuel and
plasma cutting.
Disable Control
Pressing the Disable Control soft key disables the motion command from the control to the drive
system. While disabled, I/O points and encoder feedback are still active.
Watch
Allows programming of the user definable Watch Window.
Password
Enter a password to get to the supervisor password protected setup menu.
To Next Page
Loading...
Need help?
General
