Setups 35
Show Traverse Segments
Allows traverse segment lines (displayed in yellow) to be turned OFF or ON during all part preview
displays.
Retain Skew Adjustment
The Retain Skew Adjustment feature is used to retain the last calculated plate skew for all
subsequent parts that are loaded. If disabled, any new part that is loaded will remove any previously
calculated plate skew.
THC Voltage Offset
The THC Voltage Offset parameter is used to offset the individual Sensor THC™ Arc Voltages from
the master set Arc Voltage. This allows the individual THCs to be adjusted to compensate for
consumable wear and obtain optimum cut quality.
To Next Page
Loading...
