Hypertherm MicroEdge - Joystick; THC and Joystick Cable Grounding

MicroEdge™ 492
Joystick
Pin # Designation Description
1 Input 1 Joystick UP
2 Input 2 Joystick DWN
3 Input 3 Joystick LT
4 Input 4 Joystick RT
5 Common Common
6 Analog Input 3 + Speed Pot 1
7 Analog Input 3 – Speed Pot 1
8 Analog Input 4 + Speed Pot 2
9 Analog Input 4 – Speed Pot 2
Ground Stud Shield
Note: Joystick inputs are activated by passing the Common signal ( pin 5 ) to the desired input.
Analog inputs for the speedpots are rated at 0 - +10VDC
Mating Connector
Connector AMP #206708-1
Backshell AMP #206966-1
Sockets (20-24 ga) AMP #66105-3
Cabling: Use Belden # 9504 or equivalent
THC and Joystick Cable Grounding
Cable shields should be tied to the external PE studs for optimum noise immunity.