Setups 45
Ignition Time
(Ignition Output) Specifies the length of time that the ignition output is held on at each ignition point.
Marker On Time
(Time Delay) This parameter allows the operator to insert a time delay, which allows the marker to
prepare for operation prior to the start of Marker motion.
Marker Off Time
(Time Delay) This parameter allows the operator to insert a time delay, which allows the marker to
prepare for operation prior to the end of Marker motion.
Marker Up Time
(Torch Up Output) Specifies the length of time to raise the marker at the beginning and end of each
mark.
Marker Partial Up Time
(Torch Up Output) Specifies the length of time for partial raise of the marker at the beginning and end
of each mark. Note: The Partial Raise parameter must be enabled.
To Next Page
Loading...
