Hypertherm MicroEdge - Baud Rate; Parity; Data Bits; Flow Control

Program Codes 439
After enabling Messaging, the flow control parameters to communicate with the external device will
then need to be selected. The user may also select how messaging is handled for the Jogging
Forward/Backward on Path. Additionally, the Retry on Time Out and Time Out parameters are
available .
The following parameters must be configured for use. Hardware and flow control configuration
information must match the external device.
Baud Rate
Select a communication speed from 1200 Baud to 115200 Baud
Parity
Select None, Odd or Even.
Data Bits
Select 7 or 8 Data Bits.
Flow Control
Select to use None, Xon/Xoff or Hardware.