Hypertherm MicroEdge User Manual

Files 96
Save to Disk
The following screen is used to save a part to a diskette, USB memory stick or the hard drive. Once
all the parameters below are set, press OK to save the part.
Save to
The Save to list selects whether you save to the diskette, USB memory or to a directory on the hard
disk. To add or remove a directory, double click on the touch screen where indicated.
Keypad operation: To select a different directory, use the  and  keys on the keyboard. To add a
new directory, use the + key on the keyboard. To remove a directory, use the - key on the keyboard.
File name/Diskette file name
The File name /Diskette file name is the name that you are giving the file you are loading on the disk.
Save Original Text
Selecting the Save Original Text option will save the part to disk in its original programming format.
Note: This selection is not available if saving to the Diskette or USB memory stick from the hard
drive.
Save from

Hypertherm MicroEdge Specifications

General

Brand	Hypertherm
Model	MicroEdge
Category	Control Systems
Language	English