Password Setups 310
CBH High Jog / Home Speed
Enter a value for the desired manual CBH jog and fast Home speed.
CBH Low Jog / Home Speed
Enter a value for the desired CBH slow home speed.
THC Speed Setups (Shown only when enabled)
THC Acceleration Rate
This parameter allows the operator to set the acceleration rate for smooth and stable movement of
the Sensor™ Torch Height Control. The higher the acceleration rate, the quicker the THC will get up
to speed. The lower the acceleration rate, the smoother the machine will position the cutting device.
Values are entered in milligees.
Maximum THC Speed
Enter the maximum speed for the Sensor™ THC movement in inches per minute.
THC Jog Speed
Enter a value for the desired THC jog speed.
THC Home/Fast IHS Speed
The THC Home/Fast IHS Speed entered here is used to home the torch at the top of the slide and to
move the torch from the selected IHS height towards the plate, looking for the surface of the plate.
THC Slow IHS Speed
The THC IHS Speed is used to retract the torch after the plate has been sensed. The torch will retract
at this speed until the contact sense is lost. This determines the exact distance to the plate
regardless of any flexing of the plate. A very small speed is recommended for optimal accuracy.
To Next Page
Loading...
