To Next Page

To Previous Page

Password Setups 348

Example: If Station 1 has been defined as having a Sensor™ THC and a MAX200

for Plasma

Process 1, no other power supply type can be selected for Plasma Process 1. However, MAX200

for Plasma Process 1 may be select at other stations if a Sensor THC has been selected.

Command

THC Support

Selecting a Command THC as the lifter for a process enables the serial Link to be assigned for a

single Command

THC. Note: The actual serial port must be assigned on the Ports setup screen.

This also configures the selected Plasma / Marker Cut Types screen to display the Command

THC

features. If a Command

THC has been selected for a station but does not use the serial

communication feature to the control, then the Lifter type should be set to “Other”.

Please refer to the Command

THC section of this manual for additional information on the operation

of the Command

THC

HD4070

Support

The HD4070

feature establishes the Serial Link HD4070

Power Supply communication link and

configures the selected Plasma / Marker Cut Types screen to display the HD4070

features. A single

HD4070

must be assigned to Stations 1 & 2. A second multi-dropped HD4070 may be assigned on

stations 3 & 4.

Each HD4070

has the ability to use two Integrated Command

THCs. These are controlled by the

HD4070

and as such have designated Station locations.

Hypertherm MicroEdge User Manual

Other manuals for Hypertherm MicroEdge