Hypertherm MicroEdge User Manual

Program Codes 420
EIA CODE DESCRIPTION
M308 Assigns the current X/Y position to Home Position 8
M309 Assigns the current X/Y position to Home Position 9
M310 Assigns the current X/Y position to Home Position 10
M311 Assigns the current X/Y position to Home Position 11
M312 Assigns the current X/Y position to Home Position 12
Mapped EIA Codes
EIA CODE DESCRIPTION MAPPED TO
G04 Fvalue Program Dwell G04 Xvalue
G05 Set Axis Presets G92
G21 Linear Interpolation G01
(at cut speed)
G22 CW Circular Interpolation G02
G23 CCW Circular Interpolation G03
G41 Kvalue Left Kerf with Value G41 with Kerf Value
G42 Kvalue Right Kerf with Value G42 with Kerf Value
G97 TValue Subroutine Loop G08 Xvalue and M40
G45 Lead In to Kerfed Part G01, G02, or G03
G70 Select English Units G20
G71 Select Metric Units G21
G98 End of Subroutine Loop M41
M03 Cutting Device On/Off M07 (Oxy Fuel) or M08 as appropriate
M04 Cutting Device On M07
M05 Cutting Device Off M08 (Oxy Fuel)
M06 Cutting Device Off M08
M06 Enable Marker 2 M13
M07 Disable Marker 1 or 2 M10 or M14 as appropriate
M08 Enable Marker 1 M09
M09 Disable Marker 1 or 2 M10 or M14 as appropriate
M10 Enable Marker 2 M13
M14 Height Sensor Disable M50
M15 Height Sensor Enable M51
M20 Cutting Device On/Off M07 or M08 as appropriate (Plasma)
M21 Cutting Device On/Off M07 or M08 as appropriate (Plasma)
M20 Output 9 On O9 S1
M21 Output 9 Off O9 S0
M22 Output 12 On O12 S1
M23 Output 12 Off O12 S0
M24 Wait for Input 7 On W7 S1
M25 Wait for Input 8 On W8 S1
M25 CBH Enable M29
M26 Wait for Input 7 Off W7 S0
M26 CBH Disable M28
M27 Wait for Input 8 Off W8 S0
M67, M02 Kerf Left G41
M68, M03 Kerf Right G42
M69, M04 Kerf Off G40
M65, M70 Cutting Device On M07
M66, M71, M73 Cutting Device Off M08
M70 Marker Offset 1 Off M12
M71 Marker Offset 1 On M11
M70T01 Marker Offset 1 Off M12
M71T01 Marker Offset 1 On M11

Hypertherm MicroEdge Specifications

General

Brand	Hypertherm
Model	MicroEdge
Category	Control Systems
Language	English