Hypertherm MicroEdge - Upload to Host; Resume Last Part; Show Certain Files; Show All Files

Overview 25
Upload to Host
Allows programs from the internal disk drives to be uploaded to a host computer via the selected RS-
232C/RS-422 serial port.
Resume Last Part
The Resume Last Part soft key will be visible when the Rush Job Interrupt or Automated Power Loss
Recovery feature is in use. These features allow the user to pause the current part program and
retain the part and current position information. This then allows the user to load and execute
another part program and return to the original part using the Resume Last Part soft key.
Note: Controllers with SERCOS interface will save position information every minute to the hard drive.
Some motion on path may be required for power or position loss recovery.
Show Certain Files
This soft key allows the operator to show only certain files from the selected directory. Both the
asterisk and question mark may be used in defining the files to show.
Keypad operation: The asterisk is generated by holding down the left shift key and pressing the
backspace key. The question mark is generated by holding down the right shift key and pressing the
backspace key.
Show All Files
This soft key allows the operator to undo the Show Certain Files from above.
Note: An optional Network Card for connecting directly to a PC Network for part file allocation is
available.