Hypertherm MicroEdge User Manual

Automated Plasma Interface 462
HD3070 Auto Gas Interface
This section outlines information specific to Hypertherm‟s HD3070
®
Auto Gas Interface. The Auto
Gas screen is available from the Cut Types screen.
Note: The Auto Gas feature must first be enabled at the Special Password screen and is designed for
use with the six valve autogas console only
The top of the Auto Gas screen lists the valve parameter settings for the HD3070
®
. Valve settings for
the 3070
®
Auto Gas console are documented in the HD3070
®
manual. When the values are set,
these become the current setting and the operator can choose to save the file to the diskette, USB
memory or hard drive.
The settings at the supply are updated at control power up, whenever the settings are changed at this
screen or through commands in a part program. Supply settings are also updated if power is lost and
re-enabled at the power supply. There may be a brief delay as these power supply settings are
communicated from the control to the power supply.
Save Data
Pressing the Save Data softkey will allow the operator to save the current Autogases setting to
diskette, USB memory or hard drive for future use.

Hypertherm MicroEdge Specifications

General

Brand	Hypertherm
Model	MicroEdge
Category	Control Systems
Language	English