Program Codes 423
ESSI
The control supports ESSI part programs as defined by the International Standards Organization in
ISO 6582. An ESSI program lists the sequence of Lines, Arcs, Speeds, Kerf and I/O Functions used
to create a part. While the user is free to program in ESSI using a standard text editor, it is
recommended that the ShapeWizard
Graphical Programming environment be used instead.
While the user is free to download ESSI programs to the control, it is important to note that all Part
Programs will be internally converted to EIA for execution in the control. Following is a list of the
ESSI codes that are mapped into the control, or currently unsupported by the control. Mapped ESSI
codes are automatically converted upon program load into directly supported EIA codes.
Unsupported ESSI codes are ignored. All other ESSI codes will generate an error.
Mapped ESSI Codes
ESSI CODE DESCRIPTION MAPPED TO EIA
% Start of Program Not Used-Automatic
+/-value… Line or Arc G00, G01, G02 or G03 as appropriate
0 End Program or Stop M02 or M00 (if 64 is End Program)
3 Start Comment (
4 End Comment )
5 Enable Rapid Traverse Not Used-Automatic
6 Disable Rapid Traverse Not Used-Automatic
7 Cutting Device On M07
8 Cutting Device Off M08
9 Enable Marker 1 M09
10 Disable Marker 1 M10
11 Marker Offset 1 On M11
12 Marker Offset 1 Off M12
11+1 Marker Offset 1 On M11
12+1 Marker Offset 1 Off M12
11+2 Marker Offset 2 On M73
12+2 Marker Offset 2 Off M72
11+3 Marker Offset 3 On M275
12+3 Marker Offset 3 Off M274
11+4 Marker Offset 4 On M277
12+4 Marker Offset 4 Off M276
11+5 Marker Offset 5 On M279
12+5 Marker Offset 5 Off M278
11+6 Marker Offset 6 On M281
12+6 Marker Offset 6 Off M280
To Next Page
Loading...
