Hypertherm MicroEdge User Manual

DISCLAIMER The information in this document is subject to change without notice and should not
be construed as a commitment by Hypertherm Automation
®
. Hypertherm
Automation
®
assumes no responsibility for any errors that may appear.
TRADEMARKS Hypertherm Automation is a wholly owned subsidiary of Hypertherm
®
, Inc.
ShapeWizard
®
and EDGE
®
are reg. trademarks of Hypertherm Automation.
Gemini™, Voyager™ and Mariner™ are trademarks of Hypertherm Automation.
HyperNest
®
, HyperCAD
®
and HyperNet
®
are reg. trademarks of Hypertherm
Automation.
Nester™, APC™ and Sensor™ THC are trademarks of Hypertherm Automation.
Command
®
THC and HT 4400
®
are registered trademarks of Hypertherm
®
, Inc.
HD3070
®
and HD4070
®
HyDefinition
®
Plasma are reg. trademarks of Hypertherm
®
, Inc.
HyPerformance™ and HPR130™ are trademarks of Hypertherm Automation.
Microsoft
®
and Microsoft logo are registered trademarks of the Microsoft Corporation.
Pentium
®
and Celeron
®
are registered trademarks of Intel Corporation.
NJWIN
®
is a registered trademark of NJStar Software Corporation.
Virus Scan
®
is a registered trademark of McAfee Associates, Inc.
Norton AntiVirus™ and Norton Ghost are Trademarks of Symantec™ Corp.
HASP
®
is a registered trademark of Aladdin Knowledge Systems Ltd.
SERCOS Interface™ is a trademark of SERCOS North America.
Indramat™ is a trademark of Bosch Rexroth.
Pacific Scientific™ is a trademark of Danaher Motion.
PATENTS Hypertherm Automation CNC products may be covered by one or all of the following
US Patents - US 6772040, US 6622058 or US6359251.
COPYRIGHT ©2007 by Hypertherm Automation. All rights Reserved
Printed in USA

Hypertherm MicroEdge Specifications

General

Brand	Hypertherm
Model	MicroEdge
Category	Control Systems
Language	English