Lexmark MS821

Error
code
Description Action
422.15 The bin 1 right tamper did not clear the
sensor (staple finisher right tamper) on
time.
See
“Right tamper jam service check” on page 239.
422.15 The bin 1 right tamper did not clear the
sensor (SHPF right tamper) on time.
See
“SHPF right tamper jam service check” on page 253.
422.23 The bin 2 right tamper did not reach the
sensor (staple finisher right tamper) on
time.
See
“Right tamper jam service check” on page 239.
422.23 The bin 2 right tamper did not reach the
sensor (SHPF right tamper) on time.
See
“SHPF right tamper jam service check” on page 253.
422.25 The bin 2 right tamper did not clear the
sensor (staple finisher right tamper) on
time.
See
“Right tamper jam service check” on page 239.
422.25 The bin 2 right tamper did not clear the
sensor (SHPF right tamper) on time.
See
“SHPF right tamper jam service check” on page 253.
423.13 The bin 1 ejector belt did not reach the
sensor (staple finisher ejector) on time.
See
“Staple finisher ejector drive failure service check” on
page 368.
423.13 The bin 1 ejector belt did not reach the
sensor (SHPF ejector) on time.
See
“SHPF ejector jam service check” on page 256.
423.15 The bin 1 ejector belt did not clear the
sensor (staple finisher ejector) on time.
See
“Staple finisher ejector drive failure service check” on
page 368.
423.15 The bin 1 ejector belt did not clear the
sensor (SHPF ejector) on time.
See
“SHPF ejector jam service check” on page 256.
423.23 The bin 1 ejector belt did not reach the
sensor (staple finisher ejector) on time.
See
“Staple finisher ejector drive failure service check” on
page 368.
423.23 The bin 1 ejector belt did not reach the
sensor (SHPF ejector) on time.
See
“SHPF ejector jam service check” on page 256.
423.25 The bin 1 ejector belt did not clear the
sensor (staple finisher ejector) on time.
See
“Staple finisher ejector drive failure service check” on
page 368.
423.25 The bin 1 ejector belt did not clear the
sensor (SHPF ejector) on time.
See
“SHPF ejector jam service check” on page 256.
423.51 The bin 1 motor (staple finisher ejector)
did not turn o.
See
“Staple finisher ejector drive failure service check” on
page 368.
423.51 The bin 1 motor (SHPF ejector) did not turn
o.
See
“SHPF ejector jam service check” on page 256.
423.54 The bin 1 motor (staple finisher ejector)
did not reach the required speed.
See
“Staple finisher ejector drive failure service check” on
page 368.
423.54 The bin 1 motor (SHPF ejector) did not
reach the required speed.
See
“SHPF ejector jam service check” on page 256.
423.55 The bin 1 motor (staple finisher ejector)
went over the required speed.
See
“Staple finisher ejector drive failure service check” on
page 368.
4064
Diagnostics and troubleshooting
233