Lexmark MS821

Error
code
Description Action
423.55 The bin 1 motor (SHPF ejector) went over
the required speed.
See
“SHPF ejector jam service check” on page 256.
423.61 The bin 2 motor (staple finisher ejector)
did not turn o.
See
“Staple finisher ejector drive failure service check” on
page 368.
423.61 The bin 2 motor (SHPF ejector) did not
turn o.
See
“SHPF ejector jam service check” on page 256.
423.64 The bin 2 motor (staple finisher ejector)
did not reach the required speed.
See
“Staple finisher ejector drive failure service check” on
page 368.
423.64 The bin 2 motor (SHPF ejector) did not
reach the required speed.
See
“SHPF ejector jam service check” on page 256.
423.65 The bin 2 motor (staple finisher ejector)
went over the required speed.
See
“Staple finisher ejector drive failure service check” on
page 368.
423.65 The bin 2 motor (SHPF ejector) went over
the required speed.
See
“SHPF ejector jam service check” on page 256.
424.13 The bin 1 paddle did not reach the sensor
(staple finisher paddle) on time.
See
“Staple finisher paddle jam service check” on
page 242.
424.13 The bin 1 paddle did not reach the sensor
(SHPF paddle) on time.
See
“SHPF paddle jam service check” on page 257.
424.15 The bin 1 paddle did not clear the sensor
(staple finisher paddle) on time.
See
“Staple finisher paddle jam service check” on
page 242.
424.15 The bin 1 paddle did not clear the sensor
(SHPF paddle) on time.
See
“SHPF paddle jam service check” on page 257.
424.23 The bin 2 paddle did not reach the sensor
(staple finisher paddle) on time.
See
“Staple finisher paddle jam service check” on
page 242.
424.23 The bin 2 paddle did not reach the sensor
(SHPF paddle) on time.
See
“SHPF paddle jam service check” on page 257.
424.25 The bin 2 paddle did not clear the sensor
(staple finisher paddle) on time.
See
“Staple finisher paddle jam service check” on
page 242.
424.25 The bin 2 paddle did not clear the sensor
(SHPF paddle) on time.
See
“SHPF paddle jam service check” on page 257.
425.13 The bin 1 bin clamp did not reach the
sensor (staple finisher bin clamp) on time.
See
“Staple finisher ejector drive failure service check” on
page 368.
425.13 The bin 1 bin clamp did not reach the
sensor (SHPF bin clamp) on time.
See
“SHPF ejector jam service check” on page 256.
425.15 The bin 1 bin clamp did not clear the
sensor (staple finisher bin clamp) on time.
See
“Staple finisher ejector drive failure service check” on
page 368.
425.15 The bin 1 bin clamp did not clear the
sensor (SHPF bin clamp) on time.
See
“SHPF ejector jam service check” on page 256.
425.23 The bin 2 bin clamp did not reach the
sensor (staple finisher bin clamp) on time.
See
“Staple finisher ejector drive failure service check” on
page 368.
4064
Diagnostics and troubleshooting
234