Lexmark T652 - Page 96

Error code Description Action
230.05 Sensor (duplex input) lingering jam (internal
duplex)
Media reached the sensor (duplex input) but did
not clear it in the
specified
time.
Go to
“Sensor (pass through) late jam service
check” on page 98.
230.06 Sensor (input) late jam from duplex (internal
duplex)
Media is late reaching the sensor (input) within the
specified time during the second side printing
using the internal duplex.
Go to
“Sensor (input) late jam service check”
on page 68.
230.07 Sensor (input) late jam from duplex (internal
duplex)
Media is late reaching the sensor (input) within the
specified
time during the second side printing
using the internal duplex.
230.08 Internal duplex drive motor load error (internal
duplex)
The internal duplex drive motor assembly has
failed or caused high mechanical load during
warm-up sequence.
Go to
“Internal duplex drive motor load error
service check” on page 102.
230.10 Internal duplex drive motor control failure (internal
duplex)
The internal duplex drive motor does not reach
the proper operating speed at the specified time.
Go to
“Internal duplex drive motor control
failure service check” on page 92.
230.13 Sensor (duplex input) static jam (internal duplex)
Media remains on the sensor (duplex input) during
the warm-up sequence.
Go to
“Sensor (duplex input) lingering jam
service check” on page 102.
230.14 Paper jam around internal duplex (internal duplex)
Page may be jammed in internal duplex area.
Go to
“Paper jam around internal duplex
service check” on page 97.
230.18 Internal duplex drive motor assembly underspeed
error (internal duplex)
The internal duplex drive motor does not rotate at
the
specified
speed.
Go to
“Internal duplex drive motor control
failure service check” on page 92.
230.20 Internal duplex drive motor lost encoder failure
(internal duplex)
The internal duplex drive motor is not reporting
pulses back to the engine.
Go to
“Internal duplex drive motor load error
service check” on page 102.
4062
Diagnostic information
96