L-INX User Manual 231 LOYTEC
Version 4.0 LOYTEC electronics GmbH
To Create a Time-Based M-Bus Poll Group
1. Select the M-Bus dialog by clicking on the M-Bus button
in the tool bar of the Datapoints tab. The M-Bus Management dialog opens.
2. Open the Pollgroups tab. This shows the dialog displayed in Figure 179.
Figure 179: Pollgroup Management dialog.
3. The default poll group is selected and its properties are displayed. Enter the name of
the new poll group and enter the poll cycle in seconds. Make sure that under Pollgroup
Mode Time-based is selected.
4. Press the Save button to store the poll group and continue editing.
5. If a poll group needs to be updated or deleted, select the poll group edit the data and
press the Update Selected or Delete Selected button.
6. Press the Close button to finish editing. When the poll groups have not been saved, a
dialog asks whether the changes have to be saved or not.
To Create a Trigger-Based M-Bus Poll Group
1. Select the M-Bus dialog by clicking on the M-Bus button
To Next Page
Loading...