5.23. Full key
Pressing the Full key will put the selected fixtures at a dimmer value of 100% (= full) in your programmer.
If you don't have a selection of fixtures, then this key won't do anything.
Related link
Full Command
5.24. Go- key
The Go- key is used to execute a GoBack command on an executor. It will take you to the previous cue with the
cue timing. Press this key followed by any key associated with an executor.
Don't mistake this key with the big Go- key under the main executor faders - Read about it here.
Related link
GoBack Command
5.25. Go- (Large) key
The large Go- key under the main executor faders is locked to only perform a go backwards with cue timing
on the main cue list. The function can't be changed.
The command it executes is actually called DefGoBack.
Don't mistake this key with the small Go- key in the command area - Read about that key here.
5.26. Go+ key
To Next Page
Loading...
Need help?
General