7.57. StoreLook Command
This page describes the syntax and how to use the StoreLook command.
To go to the StoreLook command, press and hold and Store on the console.
Description
With the StoreLook command, you can store your actual look as a cue on an executor.
The StoreLook command stores all dimmer values from all fixtures in the show.
If the dimmer value is bigger than 0 it stores additional all further attributes.
If the dimmer value is 0, it stores only the dimmer value because there is no further actual output of the fixture.
Syntax
Store the actual look from all fixtures in the show.
StoreLook
Example
Let´s assume you will store the actual look from all fixtures in the show as a cue on executor 1.
Press + Store (=StoreLook) and the respective executor button .
All dimmer values are stored.
All attributes are stored if the dimmer value was bigger than 0.
Related Links
MA Key
Store Key
System Colors - Values
To Next Page
Loading...
Need help?
General