Default Key
The default key slider is the one in the middle of the three.
To select the brightness of the keys in the command area, move the slider up or down.
30 % is the highest value to select.
Highlighted key
The highlighted key slider is the third one.
To select brightness of the highlighted key on the console, move the slider up or down.
100 % is the highest value to select.
To leave the Key Backlight Window, tap in the title bar or press Esc on the console.
Encoder Bar Functions
The default encoder speed is without decimal place.
To change the encoder speed into slow, that means with decimal place, press on the console.
Unused Key:
To select the brightness of the unassigned executor buttons, turn the encoder left or right.
Default Key:
To select the brightness of the keys in the command area, turn the encoder left or right.
Highlighted Key:
To select brightness of the highlighted key on the console, turn the encoder left or right.
Related Links
Setup
Encoder Key
6.35. Leaving Patch & Fixture Schedule... Window
To Next Page
Loading...
Need help?
General