7.55. Stomp Command
This page describes the syntax and how to use the Stomp command.
To go to the Stomp command press and hold + At (= Stomp) on the console.
Description
With the Stomp command, you mute running effects.
This is useful for pan tilt effects, because they are relative effects and a new pan tilt value does not mute the current
effect.
The stomp command is the same as the stomp in the effects view.
Syntax
Mute a running effect.
Stomp
Example
Let´s assume, you will mute all position preset type effects.
There are two ways to do this:
a) Open the position effects view and tap at Stomp .
b) Press + At (= Stomp) and tap at Position in the preset type bar.
All position effects are mute.
Related Links
MA Key
At Key
Effects View
7.56. Store Command
This page describes the syntax and how to use the Store command.
To go to the Store command, press Store on the console.
Description
With the Store command, you can store e.g.
a cue on an executor
a selection of fixtures as a group in the groups view
an active value in a preset pool
Syntax
To Next Page
Loading...
Need help?
General