7.5. Assign Command
This page describes the syntax and how to use the Assign command.
To go to the Assign command press and hold key and Label on the console.
Assign is in the command line, now.
Assign
Description
With the Assign command, you can create assignments between
a fixture and a DMX address
a function and an executor button
a fade time and cues of an executor
Syntax
1. Assign a fixture to a DMX address.
Assign Fixture 21 DMX 2.1
2. Assign a function to an executor button.
Assign Flash
3. Assign fade time to cues of an executor.
Assign Fade 10 Cue 2 Exec 1
4. Assign fade time to the current cue of the main executor.
Assign Fade 10
Example 1
Let´s assume, you will patch the fixture ID 21 to the DMX address 2.1.
Press + Label (=Assign) Fixture 2 1 DMX 2 . 1 Please .
The fixture ID 21 is patched to the DMX address 2.1.
Double check the correct patch in the Patch and Fixture Schedule.
Example 2
Let´s assume, you will assign a function to an executor.
To Next Page
Loading...
Need help?
General