then all programmer values will use the time your fader is set to - including when you press Clear .
Related links
What is cues
What is the Programmer
Exec (Executor) Key
Executor Command
Executor Bar
Executor Pool
3.8. What are Chasers
Chasers are cue list that have a special mode.
In this mode the cue list will disregard the stored timing and then it runs all the cues one after the other.
Since it's not using the cue timings it runs using a set speed. The standard speed is 60 Beats Per Minute (BPM). This
means that it runs 60 steps or cues per minute.
Chaser can have different running modes. The standard mode is endless loop. This will loop the cue list until you
stop it. The other modes are Shoot-Off and Shoot-On. What they do is running the cue list once. The Shoot-Off then
turns off the chaser when it reaches the last cue. The Shoot-On stops or pauses the chaser when it reaches the last
cue.
One of the other settings you can change on chasers is the running direction. The standard is forward. Other options
are Backwards, Bounce and Random. Bounce will run forward until you reach the last step and then it will run
backwards until it reaches the first step, run forward again, and so on, and so on. Random will run the steps in a
completely random order.
To learn how to make and run Chaser have a look at the How to work with Chasers.
Related links
How to work with Chasers
What are cues
Cue View
3.9. What are Effects
Effects in the dot2 are attributes that dynamically changes between two values. The dot2 comes with a set of build
in effects that you can modify.
To Next Page
Loading...
Need help?
General