6.40. Network Setup Window
To go to the Network Setup, press Setup and tap at Sessions .
In this window, you can
start, join, stop, or leave a session
add or remove devices into or from the session
The session status is independent from the show file.
Below the title bar is the session status displayed.
By default, the console is standalone. To connect other devices to the console, you need to start a session first.
To start a session, tap at Start new or join an existing session . The select session number window opens.
If the console is in a session, the session number is displayed in the session status text.
Connected Devices Area
In the connected devices area are all connected and previous connected devices displayed.
The devices are organized in the tabs
Consoles
OnPC
3D
DMX Nodes
To select a tab, tap at the device name, e.g. 3D .
To Next Page
Loading...
Need help?
General